Page Comparison

...

1. Create second Administration Application service

   

2. Configure Administration application

   Image RemovedImage Added

   1. Set the service name to Administration App - Local User to identify this is the local auth DB service

   2. Set the node/arm

   3. Set the host to the ip address of the node or 0.0.0.0 to bind to all IP addresses

   4. Set the port - this is the port that will be used to connect to the local admin access in this example 3999 was used

   5. Set the authentication policy as required

3. Via SSH allow HTTP access to the port defined above adjust the port as set in the administration application configuration

   Code Block
   yarnman@yarnman:~$ sudo ufw allow 3999 Rule added

4. Verify access to the administration application - Note that https must be used

   

...