| Page Tree | ||||
|---|---|---|---|---|
|
Overview
This guide provides information about migrating an on-premises deployment to the Cisco UCM Cloud Webex Calling Dedicated Instance (WxC-DI) using the Yarnlab Wrangler UCMC Tool. During a migration, Cisco deploys the Unified CM cluster, then an administrator at the partner configures it, replicating the on-premises source cluster/s and register the end-user devices to the UCM cloud WxC-DI post migration.
...
Wrangler supports migrations of single and multiple CUCM clusters into a single WxC-DI cluster and or to WxC-MT (from version 2.6.x).
The WxC-DI (CUCM cluster) Dialplan can be migrated using one of the following methods
...
In the Template option, Wrangler will deploy either a standardised CUCDM type dial plan or a standard Simplified Dial Plan to the target cluster, existing dial plan objects then have to be mapped to the target dial plan objects.
Deployment Architecture
Versions Supported
Yarnman Version | CUCM/ Unity | WxC-DI/ CUCM/Unity Target (Target can not be lower ver than source) | WxC-MT | ||
|---|---|---|---|---|---|
Up To and including 2.5.21 | 10.x-14.x | 12.5.x-14.x | N/A | ||
2.5.22/2.5.23 | 11.x-14.x | 11.5.x-14.x | N/A | ||
2.5.24 | 11.x-15.x | 11.5.x-15.x
| N/A | ||
2.6.x | 11.x-15.x | 11.5.x-15.x | Supported |
Migration Process
The migration process goes through a number of steps as per below pictures
...
Prerequisites
...
Hardware requirements :
...
Hardware
...
Specification
...
Virtual Machines
...
4 vCPU
8 GB vRAM
1 x 100 GB vDisk
...
Virtualization software
...
VMware vSphere ESXi 6 or higher
...
VMware Workstation support
...
12 or higher
Software Requirements: Yarnman OVA for initial installation and Yarnman installed. Virtual miachine deployed and bootstrap setup completed https://yarnlab.atlassian.net/wiki/spaces/YSP/pages/2916941825/Yarnman+Photon+Powered+YM-PH+-+Installation+and+Upgrade+Guide#Compute-Requirements
For v2.5.x The process to install Yarnman is described in Yarnman Setup Guide under interfaces chapter
...
The following configuration needs to be setup before using Wrangler UCMC
...
Minimum Mapped Objects (need to be configured on target system)
MRGL (MRG)
CMG
| Info |
|---|
Additional configuration may will be required based on source configuration - this will be visable after inital discovery in target mappings and will vary on dial plan option selected (Clone/Map) |
Data Extraction
Configuration is extracted from the source and target clusters and imported into Migration Assistant including all lines, devices, users and dial plan
Configuration can be periodically rediscovered if required for phased migrations
...