| Table of Contents | ||
|---|---|---|
|
Setup
The Setup chapter describes the required services and apps for Wrangler UCMC to operate. A prerequisite is that Yarnman server has been installed. This is described in Yarnman Setup Guide for Yarnman 2.5.x here Yarnman Installation and Setup - for yarnman 2 yarnlab legacy documentation - v2.5.x and Yarnman 2.6.x here Yarnman Photon Powered (YM-PH) v2.6.x+
...
To setup Wrangler UCMC, Log in to Yarnman, open Administration App->Services
Wrangler UCMC will require two services described below
Wrangler OPA App
Interconnect Service
wrangler_
To add wrangler_ app, From Top right corner of display drop down +Add Service, select Wrangler OPA Migration App
...
Define Service Name, select Yarnman Node, Select UCM Migration Assistant Migration, select required Authentication policy from drop down, then Submit
...
Select Services from Menu → Select either Proxy Service or Standalone Proxy Service depending on which proxy service is present by default (Do not add a new proxy service unless specifically required)
...
wrangler_
On Next screen
Populate Service name or accept prepopulated
Select Node/ Arm - normally this is Standalone unless arms have been installed
Migration Type Webex Calling MT & DI
Authentication Policy Central DB-Only Policy
then Submit
Now we need to add wrangler_ service to proxy
Select Services from menu; then
Select Proxy Service
From Proxy Configuration Page, select ‘Service Routing’ from top right corner
...
The Wrangler UCMC app has now been added and may be selected from top Right Drop down
...
Set up Interconnect Service
Select Services from Menu, then + Add Service, from drop down select Interconnect Service
Populate Service Name Field, select node from Node / Arm field drop down, then select Submit
...