...
The Setup chapter describes the required services and apps for Wrangler UCMC to operate. A prerequisite is that Yarnman server has been installed. This is described in Yarnman Setup Guide for Yarnman 2.5.x here Yarnman Installation and Setup - for yarnman 2 yarnlab legacy documentation - v2.5.x and Yarnman 2.6.x here Yarnman Photon Powered (YM-PH) v2.6.x+
...
To setup Wrangler UCMC, Log in to Yarnman, open Administration App->Services
Wrangler
...
Wrangler UCMC will require two services described below
Wrangler OPA App
Interconnect Service
From Top right corner of display drop down +Add Service, select Wrangler OPA Migration App
...
Define Service Name, select Yarnman Node, Select UCM Migration Assistant Migration, select required Authentication policy from drop down, then Submit
...
Select Services from Menu → Select either Proxy Service or Standalone Proxy Service depending on which proxy service is present by default (Do not add a new proxy service unless specifically required)
...
From Proxy Configuration Page, select ‘Service Routing’ from top right corner
...
Select ‘Add Yarnapp' and from the drop down, select the Wrangler Migration App ->Submit
...
The Wrangler UCMC app has now been added and may be selected from top Right Drop down
...
Set up Interconnect Service
Select Services from Menu, then + Add Service, from drop down select Interconnect Service
Populate Service Name Field, select node from Node / Arm field drop down, then select Submit
...
Wrangler 2.6.X Setup
Wrangler will require two services described below
wrangler_
interconnect_
wrangler_
To add wrangler_ app, From Top right corner of display drop down +Add Service, select wrangler_
...
The Wrangler UCMC app has now been added and may be selected from top Right Drop down
...
Again Select Services from menu
...
Populate
Service Name - accept prepopulated or change as required
Select Node / Arm - normally this is Standalone unless arms have been installed
the Submit
...