Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

This setup can be used when the primary authentication is LDAP based to provide backup access incase of LDAP connection issues, Note that this method will use a local Yarnman authentication

  1. Create second Administration Application service

  2. Configure Administration application

    1. Set the node/arm

    2. Set the host to the ip address of the node or 0.0.0.0 to bind to all IP addresses

    3. Set the port - this is the port that will be used to connect to the local admin access in this example 3999 was used

    4. Set the authentication policy as required

  3. Via SSH allow HTTP access to the port defined above adjust the port as set in the administration application configuration

    yarnman@yarnman:~$ sudo ufw allow 3999
    Rule added
  4. Verify access to the administration application - Note that https must be used

  • No labels