Setup

The Setup chapter describes the required services and apps for Wrangler UCMC to operate. A prerequisite is that Yarnman server has been installed. This is described in Yarnman Setup Guide for Yarnman 2.5.x here Yarnman Installation and Setup - for yarnman 2.5.x and Yarnman 2.6.x here Yarnman Photon Powered (YM-PH) v2.6.x+

Required Services

To setup Wrangler UCMC, Log in to Yarnman, open Administration App->Services

Wrangler 2.5.X Setup

Wrangler UCMC will require two services described below

• Wrangler OPA App

• Interconnect Service

From Top right corner of display drop down +Add Service, select Wrangler OPA Migration App

Define Service Name, select Yarnman Node, Select UCM Migration Assistant Migration, select required Authentication policy from drop down, then Submit

Select Services from Menu → Select either Proxy Service or Standalone Proxy Service depending on which proxy service is present by default (Do not add a new proxy service unless specifically required)

From Proxy Configuration Page, select ‘Service Routing’ from top right corner

Select ‘Add Yarnapp' and from the drop down, select the Wrangler Migration App ->Submit

The Wrangler UCMC app has now been added and may be selected from top Right Drop down

Set up Interconnect Service

Select Services from Menu, then + Add Service, from drop down select Interconnect Service

Populate Service Name Field, select node from Node / Arm field drop down, then select Submit

Wrangler 2.6.X Setup

Wrangler will require two services described below

• wrangler_

• interconnect_

First we need to add an Interconnect service as follows

• Service Name - accept prepopulated or change as required

• Select Node / Arm - normally this is Standalone unless arms have been installed
  the Submit

After Interconnect service has been created, we add the wrangler_ app.

From Top right corner of display drop down +Add Service, select wrangler_

On Next screen

• Populate Service name or accept prepopulated

• Select Node/ Arm - normally this is Standalone unless arms have been installed

• Migration Type Webex Calling MT & DI

• Authentication Policy Central DB-Only Policy
  
  then Submit

Now we need to add wrangler_ service to proxy

• Select Services from menu; then

• Select Proxy Service

From Proxy Configuration Page, select ‘Service Routing’ from top right corner

Select ‘Add Yarnapp' and from the drop down, select the Wrangler Migration App ->Submit

The Wrangler UCMC app has now been added and may be selected from top Right Drop down

Again Select Services from menu