Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 16 Next »

Overview

This guide provides information about migrating an on-premises deployment to the Cisco Webex Calling Dedicated Instance (WxC-DI) using the Yarnlab Wrangler. During a migration, Cisco deploys the Unified CM cluster, then an administrator at the partner configures it, replicating the on-premises source cluster/s and register the end-user devices to the WxC-DI post migration.

Wrangler supports migrations of single and multiple CUCM clusters into a single WxC-DI cluster and or to WxC-MT (from version 2.6.x).

The CUCM cluster Dialplan can be migrated using one of the following methods

  • Clone

  • Map

  • Template

The Clone option will clone the existing dial plan to the target CUCM cluster as is (this option is not supported for Multi Cluster migration).

The Map option requires that a dialplan is manually configured on the target cluster prior to migration, existing dialplan objects then have to be mapped to the target dial plan objects.

In the Template option, Wrangler will deploy either a standardised CUCDM type dial plan or a standard Simplified Dial Plan to the target cluster, existing dial plan objects then have to be mapped to the target dial plan objects.

Versions Supported

Yarnman Version

CUCM/ Unity
Source

WxC-DI/ CUCM/Unity Target

(Target can not be lower ver than source)

WxC-MT

Up To and including 2.5.21

10.x-14.x

12.5.x-14.x

N/A

2.5.22/2.5.23

11.x-14.x

11.5.x-14.x

N/A

2.5.24

11.x-15.x

11.5.x-15.x

For v15 only clone is supported

N/A

2.6.x

11.x-15.x

11.5.x-15.x

Supported

Migration Process

The migration process goes through a number of steps as per below pictures

Prerequisites

Recommendations for using the Wrangler UCMC Tool

Hardware requirements :

Hardware

Specification

Virtual Machines

4 vCPU

8 GB vRAM

1 x 100 GB vDisk

Virtualization software

VMware vSphere ESXi 6 or higher

VMware Workstation support

12 or higher

Software Requirements: Yarnman OVA for initial installation and Yarnman installed. The process to install Yarnman is described in Yarnman Setup Guide under interfaces chapter yarnlab legacy documentation - v2.5.x

The following configuration needs to be setup before using Wrangler UCMC

  • LDAP configuration

  • MOH files

  • Announcements

  • CUCM Native dial plans (COP Load)

  • Locale (COP Load)

  • TFTP files (backgrounds/ringtones)

  • Device Packs (target firmware)

  • Clusterwide Service parameters (comparison report is available)

  • Enterprise parameters (comparison report is available)

  • SNMP/SYSLOG/CDR

Minimum Mapped Objects (need to be configured on target system)

  • MRGL (MRG)

  • CMG

Data Extraction

  • Configuration is extracted from the source and target clusters and imported into Migration Assistant  including all lines, devices, users and dial plan

  • Configuration can be periodically rediscovered if required for phased migrations

  • No labels

yarnlab website